Remote Programing Video
This video explains "How to program your CrimeStopper remote" and "How to get in and out of multi-vehicle mode".
(1) How to program your CrimeStopper remote:
A - To program your remote you will need to turn the ignition to the ON position, generally this is the second position or just before the vehicle cranks the starter.
B - Next we will need to locate the programming/valet button. There is no single location for this button as it is up to the installation facility and installer on where it will be mounted.
C - On this vehicle, the switch was mounted behind the side panel of the left side of the dash.
D - Once you have located the valet button; press the button 4 times with a short pause in-between each one (approximately once every second). After the fourth press - if done correctly - the parking lights will flash 4 times letting you know you are in programming mode.
a) If you are programming a remote with keyless entry - like we are here - press the LOCK button to pair the remote.
b) If you are programming a single button remote, press the START button.
E - The parking lights will flash for each remote that you program. Once for the first, twice for the second and so on up to 4 remotes.
NOTE: When you enter remote programming mode, it will remove all previous remote codes from the system. We recommend that you have all remotes for the system physically with you at the time of programming.
F - After all of the remotes have been programmed, simply turn the ignition OFF to exit programming.
(2) How to get in and out of multi-vehicle mode:
A - To switch from Vehicle #1 to Vehicle #2, press and hold the VEH button on the remote until the LED changes from BLUE to RED. This should take approximately 5 seconds.
B - To switch from Vehicle #2 to Vehicle #1, press and hold the VEH button on the remote until the LED changes from RED to BLUE. This should take approximately 5 seconds.